Regulation And Operation; Electrical Connections - DeLonghi Holmo Fluid Instructions Manual

Electric radiator
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 47
During installation, make sure the power cable is
disconnected from the power line.

3.2 ELECTRICAL CONNECTIONS

You are recommended to have the appliance in-
The appliance must be installed in compliance with
national legislation regulating electrical equipment
and installations.
When the appliance is installed, make sure the pow-
er is off and the mains switch is in the "O" position.
The appliance requires a 230 V ~ 50 Hz power sup-
data given in table 1.
connecting switch allowing the appliance to be dis-
included the Pilot Wire, when present, in accordance
with the wiring rules.
If the appliance is installed in a bathroom, the power
nected using a connector block placed within a
When installing the appliance in damp rooms
(kitchen, bathroom), the point of connection with
the household mains must be at least 25 cm from
If the Pilot Wire is not connected to the pro-
gramming unit, it must be terminated and insu-
lated. Under no circumstances should the Pilot
Wire be connected to the earth.
Fig. 8
Appliance cable
-
-
-
PHASE = BROWN
NEUTRAL = GREY
PILOT WIRE = BLACK
Two possible cases
Case 1°: installation
without Pilot Wire
Case 2: installation
with Pilot Wire
45
into contact with the surface of the appliance (Fig. 6).

4. REGULATION AND OPERATION

The appliance is designed to heat
rooms. Some parts of this product
burns. Particular attention has to be
given where children and vulnerable
people are present.
least 50 cm from the appliance. Do not vaporise
ance.
Never touch the appliance with wet or damp hands
or feet. Do not wet the electronic control unit with
When the appliance is installed at high altitude,
the air will be hotter than the set temperature.
Possible traces of oil noted on the bottom of the
cation process. Clean the part with proper precau-
reoccurs, follow the instructions in Chapter 7.
sion of the materials.
PHASE
Household mains
NEUTRAL
Terminate and insulate
the wire
Connect to the Pilot Wire control unit or
-
-
EN
-
-

Advertisement

Table of Contents
loading

Table of Contents