Specifications; General Information; Positioning And Installing - DeLonghi Holmo Fluid Instructions Manual

1. SPECIFICATIONS OF THE APPLIANCE
Voltage: 230 V ~ 50 Hz
Insulation class: II
Protection class: IP24
Power [W] Length [cm]
1000 60
1500 84
1800 100
Table 1
indicated on the rating plate on the side of the ra-
diator (Fig. 1).
A Brand/Manufacturer
B
C Bidimensional Code (QR)
EN
D Protection class
E CE marking

2. GENERAL INFORMATION

The package contains:
– the appliance
– remote control (if provided) with two batteries and
container for wall mouting
– mounting kit
– instructions
and use. Keep for future consultation.
Install and use the appliance as described in these
These instructions do not cover all situations which
might arise. Caution and common sense should be
applied when installing, operating and servicing the
appliance.
Make sure the appliance is complete and undam-
aged. If damaged, do not use the appliance, but
are therefore recommended to dispose of them in
special differentiated waste collection containers.
Height Weight Rated current
[cm] [kg] [A]
58 13 4,5
58 19 6,5
58 23 8
F Double isolation
G Disposal procedures
H
I Voltage and Power
L Serial number

3. POSITIONING AND INSTALLING

The appliance is designed to heat domestic rooms
or similar. It must not be used for other purposes.
on a wall as described in the instructions.
Install the appliance with the control panel at the
top (Fig.2).
In bathrooms (with bath or shower), install the ap-
pliance outside zone 1 (Fig. 2).
the electronic controls and other control devices
shower (Fig. 2). The electronic controls and other
pliance must not be connected with a plug.
For radiators with power plugs, see the
warnings on page 56.
Never install the appliance:
–
–
–
or pressure vessels.
Make sure there are no pipes or electric wires in the
wall which could be damaged while mounting the
appliance.
The appliance is equipped with a sensor which
can detect an Open Window, if present above the
radiator or within the room. For a proper opera-
installation directions reported in Ch. 4.3.1 before
wall mounting.
3.1 WALL MOUNTING
Make sure the screws and anchors included in the
cal dealer.
wall. Follow the installation sequence shown on
the folding leaf of the cover (Scheme 1), respecting
the minimum distance between the bottom of the
44
-
-