Table of Contents
Advertisement
Common Problems
The system does not boot or show video at power on.
•
If configuring with only one processor verify that the processor is in the
Primary Processor slot and the termination card is in the Secondary
Processor slot. (See the server board components diagram on page 26).
•
Beep code 1-3-3-1 means you have unrecognized or bad memory. Remove
DIMMs one at a time to isolate which one is causing problems.
•
Your power supply must provide 0.8 A of +5 V Standby current to support
WOL. If the standby current is not present, your board will not boot.
The reset button does not work.
•
You may have installed the reset cable backwards. Turn off your system,
open the chassis, unplug the reset cable from the server board, turn it
around, and plug it back in. Then close your system and turn it on.
The system sometimes works, but is exhibiting erratic behavior.
•
This is typically the result of using a under-powered power supply. Make
sure it's at least a 350 W power supply.
24
SBT2 Server Board Quick Start Guide
Advertisement
Table of Contents
