Install The Server Board - Intel SBT2 Quick Start Manual

Install the Server Board

The screws for installing the server board are shipped with the chassis. You
may need to move cables out of the way to properly install your server board.
1 Remove the top piece of foam epac from the system fans.
2
Tilt the board into the chassis I/O connector end first. Position the board
so the screw holes line up with the standoffs. There are two positioning
standoffs (D) that extend into the holes on the server board. These two
standoffs will help you position the board correctly. Make sure the I/O
connectors stick out through the I/O shield. Look through the holes in the
I/O shield to make sure that the metal tabs on the I/O shield are on top of
the USB and NIC connectors, not inside.
3 Insert one screw through one of the mounting holes of the board and into a
threaded standoff. Do not tighten the screw until the next step.
4
Insert the remaining screws through the mounting holes and into the
threaded standoffs. Make sure the board is properly seated, then tighten all
the screws firmly, starting with the screws in the center of the board.
A
B
D
E
10
D
D
C
SBT2 Server Board Quick Start Guide
OM10427