Intel SBT2 Quick Start Manual page 3

Items Provided on the Bootable CD-ROM
SBT2 Server Board Product Guide
®
Intel SC5000 Server Chassis Subassembly Product Guide
Software drivers and utilities
† †
To view the product guides, boot to Windows 95/Windows NT /
† †
Windows 98/Windows 2000 and use Adobe Acrobat .
Safety and Regulatory Compliance
See the SBT2 Server Board Product Guide for product Safety and EMC
regulatory compliance information.
Intended uses: This product was evaluated for use in servers that will be
installed in offices, computer rooms, and similar locations. Other uses require
further evaluation.
EMC testing: Before computer integration, make sure that the chassis, power
supply, and other modules have passed EMC testing using a server board with a
microprocessor from the same family (or higher) and operating at the same (or
higher) speed as the microprocessor used on this server board.
Server board diagram label provided: Place the label inside the chassis in an
easy-to-see location, preferably oriented similarly to the server board.
I/O panel label provided: Place the label on the I/O shield. The cut outs are for
the top serial port and the parallel port.
Minimum Hardware Requirements
To avoid integration difficulties and possible board damage, your system must
contain the following minimum requirements. For a list of qualified memory
and chassis components see
http://support.intel.com/support/motherboards/server/SBT2/compat.htm
Processor
® ® TM
Minimum of one Intel Pentium III Xeon processor and a processor
termination card. The SBT2 server board only supports processors with the
following product codes: BX80526KB866256, BX80526KB001256,
BX80526KB933256.
Memory
Minimum of 64 MB of 133 MHz, 3.3 V, PC/133 compliant registered SDRAM
on 168 pin gold DIMMs.
Power Supply
Minimum of 350 W with 0.8 A +5 V standby current (in order to support
†
Wake On LAN (WOL)). You must provide standby current, or the board will
not boot.
SBT2 Server Board Quick Start Guide 3