Configuring Physical Port Parameters on 10-
Gigabit Ports
Overview
Web Agent
Procedure
Part No. 610-0211-094
On each switch, you then need to create a separate VLAN (VLAN ID
100) for the routed traffic and an IP interface (192.168.1.x) and
enable a routing protocol such as RIP version 2 on the IP interfaces.
Figure 12. Routed Network Example
VLAN 1
VLAN 2
VLAN 3
VLAN 4
VLAN 5
You can configure the physical port parameters on 10-Gigabit ports
by using either the Web Agent or the CLI.
For detailed information about each parameter, see Table 13.
To configure a port on a 10-Gigabit module by using the Web Agent:
1. In the navigation pane, expand the Modules & Ports folder.
2. Select Configuration.
The Module Information Web page is displayed in the
content pane (Figure 13).
Separate VLAN 100
192.168.1.1
192.168.1.2
December 2, 2002
Doc. No. 650-100-701
VLAN 6
VLAN 7
VLAN 8
VLAN 9
VLAN 10
A-5