Configuring Switch Port Parameters - Avaya P580 User Manual Addendum

User Guide Addendum for the Avaya P580 and P882, v5.4

Configuring Switch Port Parameters

Overview
Trunk Mode
Hunt Group
NEDR
A-10
For information about configuring switch port parameters on 10-
Gigabit ports, see "Configuring Switch Port Parameters," in Chapter
5, "Configuring Port Parameters," of the Avaya P550R, P580, P880,
and P882 Multiservice Switch User Guide, Version 5.3.1.
Note the following 10-Gigabit-specific information.
The 10-Gigabit module supports a Trunk Mode setting of
IEEE802.1 Q or Clear.
For the 10-Gigabit module, a need for redundancy would probably
be the reason that you use a hunt group.
* Note: All ports that participate in the same hunt group must
have the same bandwidth. Thus, 10-Gigabit ports can
participate only in a hunt group that consists of other
10-Gigabit ports.
The Network Error Detection and Recovery (NEDR) feature is
supported on the 10-Gigabit module.
For information about this feature, see "Network Error Detection
and Recovery," in Chapter 5, "Configuring Port Parameters," of the
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide,
Version 5.3.1.
* Note: The Link LED on the 10-Gigabit module does not
indicate a disabled status. The LED should flash green
when you or the Network Error Detection and Recovery
(NEDR) feature disable the port. However, the LED
remains solid green.
* Note: Occasionally, if you use the set port network-error-
detection command to enable network error detection
(NEDR) on a 10-Gigabit port, the following error
message is displayed:
Set port network-error-detection failed:
<10-Gigabit port number>.
December 2, 2002 Part No. 610-0211-094