Connect Mic Cables To The Mx104 Router - Juniper MX104 Quick Start Manual

2. Plug the RJ-45 end of the serial cable into the CONSOLE port on the Routing Engine
shows the connector.
3. Plug the female DB-9 end into the device's serial port.
NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Figure 7: Routing Engine Console Cable Connector
Figure 8: Console Connections
CONSOLE/AUX
port

Connect MIC Cables to the MX104 Router

1. Have ready a length of the type of cable used by the component. For MIC cable specifications, see the
MX Series Interface Module
2. Remove the rubber safety plug from the cable connector port.
Figure 8 on page 13 shows the ports.)
Console Server
Reference.
PC
(Figure 7 on page 13
13