Connect Dc Power To A Dc-Powered Mx104 Router - Juniper MX104 Quick Start Manual

Niversal routing platforms

Hide thumbs Also See for MX104:

Table of Contents

NOTE:

Each power supply must be connected to a dedicated AC power feed and a dedicated

customer site circuit breaker. We recommend that you use a dedicated customer site circuit

breaker rated for 10 A (100 VAC), or as required by local code.

5. Secure the power cord with the power cord retainer clip.

6. Dress the power cord appropriately. Verify that the power cord does not block the air exhaust and

access to router components, or drape where people could trip on it.

7. Repeat Step

through Step

8. Observe the LED on the power supply. The LED blinks green as it transitions online. If the power supply

is functioning normally, the LED lights green steadily.

If the LED is red or not lit, the power supply is not functioning normally. Repeat the cabling procedures.

Figure 9: Connecting an AC Power Cord to an MX104 AC Power Supply

Connect DC Power to a DC-Powered MX104 Router

To connect power to the DC-powered router, you need the following tools:

Phillips (+) screwdriver, number 2

ESD grounding wrist strap

for the remaining power supply.

Table of Contents