Solid-State Drive; Memory Module - HP Chromebox G3 Maintenance And Service Manual

Solid-state drive

To remove the solid-state drive, use this procedure and illustration.
Table 6-6 Solid-state drive description and part number
Description
128 GB, 2230, PCIe, NVMe, value solid-state drive
Solid-state drive absorber
Before removing the solid-state drive, follow these steps:
1. Prepare the Chromebox for disassembly
2. Remove the bottom cover
3. Remove the I/O side frame
4. Remove the bottom shield
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.9 screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by sliding it away from the slot at an angle.
Reverse this procedure to install the solid-state drive.

Memory module

To remove the memory module, use this procedure and illustration.
Table 6-7 Memory module description and part numbers
Description
8 GB (DDR4, 3200 GHz, 1.2 V)
4 GB (DDR4, 3200 GHz, 1.2 V)
ENWW
(Preparation for disassembly on page
(Bottom cover on page 27).
(I/O side frame on page 28).
(Bottom shield on page 29).
Spare part number
M11040-005
M24278-001
27).
Spare part number
L46598-005
L83673-005
Component replacement procedures 33