Power Button Board - HP Chromebox G3 Maintenance And Service Manual

1. Prepare the Chromebox for disassembly
2. Remove the bottom cover
1. Remove the I/O side frame
2. Remove the bottom shield
3. Remove the system board
Remove the top shield:
1. Remove the four Phillips M2.5 × 5.0 screws (1) that secure the top shield to the top cover.
2. Lift the rear edge of the top shield (2) until it rests at an angle.
3. Remove the top shield (3).
Reverse this procedure to install the top shield.

Power button board

To remove the power button board, use these procedures and illustrations.
Table 6-12 Power button board description and part number
Description
Power button board
Before removing the power button board, follow these steps:
1. Prepare the Chromebox for disassembly
2. Remove the bottom cover
1. Remove the I/O side frame
2. Remove the bottom shield
3. Remove the system board
4. Remove the top shield
40 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page 27), and then remove the following components:
(I/O side frame on page
(Bottom shield on page
(System board on page
(Preparation for disassembly on page
(Bottom cover on page 27), and then remove the following components:
(I/O side frame on page
(Bottom shield on page
(System board on page
(Top shield on page 39).
27).
28).
29).
35).
27).
28).
29).
35).
Spare part number
M24724-001
ENWW