Heat Sink - HP Chromebox G3 Maintenance And Service Manual

1. Remove the I/O side frame
2. Remove the bottom shield
3. Remove the system board
Remove the fan:
1. Turn the system board right side up with the front toward you.
2. Disconnect the fan cable (1) from the system board.
3. Remove the two Phillips M2.0 × 4.0 screws (2) that secure the fan to the system board.
4. Remove the fan (3).
Reverse this procedure to install the fan.

Heat sink

To remove the heat sink, use these procedures and illustrations.
Table 6-10 Heat sink description and part number
Description
Heat sink (15 W, includes replacement thermal material)
Before removing the heat sink, follow these steps:
1. Prepare the Chromebox for disassembly
2. Remove the bottom cover
1. Remove the I/O side frame
2. Remove the bottom shield
3. Remove the system board
4. Remove the fan
38 Chapter 6 Removal and replacement procedures for authorized service provider parts
(I/O side frame on page
(Bottom shield on page
(System board on page
(Preparation for disassembly on page
(Bottom cover on page
(I/O side frame on page
(Bottom shield on page
(System board on page
(Fan on page 37).
28).
29).
35).
27), and then remove the following components:
28).
29).
35).
Spare part number
M24726-001
27).
ENWW