Audiovox Microcruise IV Installation And Owner's Manual page 8

r SERVO ASSEMBL y MOUNTIN I
I. NOTE: 00 NOT MOUNT SERVO
ASSEMBLY IN nIB FOu.oWING AREAS:
a. Under the felKIcr
b. U..r the vehicle
c. DirectJyto the eDgiM or bi)llrhead
d With cable JX)inted ckJwn
e. Near sharp. bot or DMJViDg OOjects
f. Near ignition coil (No clC*r than 10-)
g. In the passenger --t (noise)
h. Where it will interfere with selVice checks
2. When you have selected a possible location. set
the Senro AIIeIDbly unmounttd in that area.
The rcason for leaving the Servo Auembly
unmounttd is to make ~ the Barneu
AIIeIDbly will ~h the Servo AIIeIDbly
and the Cable AIIeIDbly will reach the throttle
attachingpoint.
3. Once you have oonfirmcd that the Bar8ell
AueIDbly and the Cable AueIDbly win reach
their respective locations. mount the Sen'O
AIIeaIbly in tbe spot you have selected with
Screws provided in tbe kit. (Figure 2)
,',,'
MEASURING THROn'LE TRA VEL "
ni. i. a very importut ltep. Failure to detenniae nrottle Tnvel could caule damaF to yCMIr vehicle
lad/or Cnile Coatrol Syltem.
Me re only with eagiae OFF. The Servo Assembly Cable moves 1-5/8" (41 millimcters).
To ~ thrott1c tm'e1. oaswe the distance from position. A. (Idle) to position ~. (W~ ~~).
(Fiau~ 3, 4 & ~
F Fona t17S6. p..
I c ,