Table of Contents
Advertisement
Harness Assembly
I. Plug Bamess Assembly into Servo Assembly.
Be sure to push Rubber Grommet securely into
place. (Figure 35) Place cover onto the Servo
Assembly and securely fasten screws.
(Figure 36)
--Saw
Aaembly
~
.
Rubber Oiw
~
nGURE
35
Harness ASIeIDbly
2. Straighten the Harness Assembly
and find
the 4 pin mating connectors. Separate the
4 pin connectors.
A small screw driver may
be needed.
3. Hamess Assembly needs a 314" hole to pass
through bulkhead. You may find one nearby
such as the speedometer cable hole or a small
one you can file larger. If you find the right
size hole in the right place, remove rubber
grommet. If not, drill, saw, or punch a 314"
hole in bulkhead. A hole a couple of inches
to the left or slightly higher than the steering
column is usually a good place. (Figure 37)
NOTE: Check inside before drilling, sawing
or filing so you don't damage anything.
4. From engine side, pass four pin connector
and VIOLET wire through hole. If you did
not hook up the BLUE T ACH wire and
GRA y VSS wire under the hood, pass them
through to the inside also.
s. Reattach 4 pin mating connectors and make
necessary wire connections.
(See page 19)
Sealing Bulkhead
Seal hole in bulkhead with Sealing Putty as
shown in Figure 38.
Form #2756, Page 18
Advertisement
Table of Contents
