Related Manuals for Audiovox 128-6927
Summary of Contents for Audiovox 128-6927
- Page 1 Rear Observation System Package Model RVMPKG3 Installation Manual Features: Rearview Mirror with 4” LCD 2 Built in Speakers Rearview Camera Input Auxiliary Video Input...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Cautions!…………………………………………. .……… 3 Preface………………………………………….……..…… 4 WARNING…………………………………….….…….. 4 Backing up vehicle……………………………….….….. 4 Packing list………………………………………….… 4 1. Installation Instructions ….….…………………..…5 2. Signal Inputs…………………………………….… 6 3. Controls and Indicators ……………………………6 SW1 and SW2…………………………………….……8 Specifications………………………………………………. 8 General……………………………………………….. 8 Maintenance………………………………………………... 9 Troubleshooting……………………………………………. 9... -
Page 3: Cautions
Do not use any features of this system to the extent it distracts you from safe driving. Your first priority while driving should always be the safe operation of your vehicle. Audiovox Electronics Corporation cannot accept any responsibility whatsoever for accidents resulting from failure to observe these precautions or safety instructions. -
Page 4: Preface
There is a blind spot that exists at the back of a vehicle while the vehicle is in reverse. Equipped with a camera, this electronic rearview mirror ensures safety by providing the driver with a clear and wide image of the area behind the vehicle whenever SW1 is pressed. -
Page 5: Installation Instructions
Fastening Belts Rearview Camera Camera Cable 1. Installation Instructions (1) Mount the mirror/monitor onto the existing rearview mirror. Take the two belts and slide them into the slots on the top rear of the mirror with grooved side of the belt facing down.. b) Take the buckles and slide them into the lower slots on the rear of the mirror with the buckle facing down toward the strap. -
Page 6: Signal Inputs
rearview mirror onto the existing mirror from one side with one fixed belt. Then fasten the other belt on the other side of the mirror. To prevent the mirror from falling off, tighten the belts until secure to the factory rearview mirror on both sides. Cut off excess part of straps Wiring the System. -
Page 7: Controls And Indicators
end of the Main Cable . (2) Audio/Video Input Plugs (RCA) are located at the end of the Main Cable. By connecting video and audio signals with these plugs, the user can enjoy watching video, only while the parking brake is on. Controls and Indicators Figure 5 Figure 6... -
Page 8: Sw1 And Sw2
Figure 6 illustrates the controls and indicators of the (RVMPKG3) rear view mirror A: Rearview mirror B: 4” LCD panel C: Brightness Control knob D: Power indicator (Red when power is on) E: Volume Control Knob F: Switch 1 (see below) G: Switch 2 (see below) H: Speakers SW1 and SW2:... -
Page 9: Maintenance
Contrast ratio LCD Viewing Angle Resolution Video Format Display Format Your rearview mirror requires little care, however to maintain it in optimum condition follow the procedures below: 1. Keep your system away from excessive moisture, extreme heat or cold and magnetic fields. 2. - Page 10 No video signal appears while reversing the car? Video image is not sharp enough? Check the LCD Contrast (Brightness) control knob whether the contrast knob is set too low. Check the rearview Camera lens. Check the rearview Camera wiring and connection.
- Page 11 Figure 7...
- Page 12 © 2003 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-6927...