Do not use any features of this system to the extent it distracts you from safe driving. Your first priority while driving should always be the safe operation of your vehicle. Audiovox Electronics Corp. cannot accept any responsibility whatsoever for accidents resulting from failure to observe these precautions or safety instructions.
TABLE OF CONTENTS Warnings Product description Packing list Installation Instructions 1. Signal Input 2. Control and Indicator 3. Auxiliary Input Switch Specifications Maintenance Troubleshooting Illustration of connections...
Product Description There is a blind spot that exists at the back of a vehicle while the vehicle is in reverse. Equipped with a camera, this electronic rearview mirror provides the driver with a clear and wide image of the area behind the vehicle whenever the vehicle is shifted into reverse.
CMOS1 Camera Parts list included with camera installation manual Camera Cable 1. Installation Instructions (1) Mount the mirror/monitor a). Take the two belts and slide them into the slots on the top rear of the mirror with the grooved side of the belt facing down.
d). Trim off excess length of the straps. e). Place (hide) the monitor cable behind the windshield trim piece down under the dash area. (2) Wiring the Monitor a) RED FUSED WIRE: 12VDC ACCESSORY SOURCE Connect this wire to a source that has 12 volts when the Ignition key switch is turned on, and 0 volts when the Ignition key switch is turned off.
3. Controls and Indicators Figure 5 illustrates the controls and indicators of the RVMPKG4(V2.0) rear view mirror: A: Rearview mirror C: Brightness control knob Figure 4 Figure 5 B: 4" LCD panel D: Power indication (Red when ignition is on)
E: Speaker volume control G: Speaker in rear of mirror Auxiliary Input Switch: Auxiliary input switch: To access the 2 The parking brake must be engaged in order to view the 2 General Power Supply Power Consumption Current Draw Video Input/Output Audio Input Audio Power Output Overall Dimension...
Though your Rearview mirror requires little care, you can still maintain its condition and performance following the procedures below. • Keep your system away from excessive moisture, extreme heat or cold and magnetic fields. • Keep liquids away from the display mirror. •...
Symptoms The ON/OFF signal light <D> is not on after the car is started? No video signal appears while reversing the car? Video image is not sharp enough? Troubleshooting 1. Check the installation-wiring diagram. 2. Ensure that the parallel red and black line from the control box is connected properly.