Audiovox Microcruise IV Installation And Owner's Manual page 11

\
T -Bar Adapler
BeadCbain
Cdver
" Top Pulley
/ Segnle~t
Bead Chain
Conncctoi
nGURE 10
B. Pullev Assemblv mua/J UsinL-' the T-BAR
ADAPTER (250-4184J
I. Remove air cleaner to expose the dual pulley
segments.
2. Find the blank anchor that is located above the
throttle anchor. Follow the instructions in STEP B
for Anchoring Cruise Cable -page IS.
3. Attach a Bead CbaiD COnDectOr onto the Cable
Assembly. (Figure 10)
4. Attach the T-Bar Adapter to the top pulley
segment. Slide the Bead CbaiD Cover onto the
T-Bar Adapter-
S. Attach the T-Bar Adapter to the Bead CbaiD
ConDector. Make sure to slide the Bead CbaiD
Cover over Bead Chain Connector. (Figure II)
Cable Assembly
~
c Pedal Attachment
I. Select a Tube Clamp that fits arowtd the top of the
accelerator pedal shaft. Make sure the tabs of the
Tube Clamp point away from the bulkhead.
2. Attach the Bead Chain to the Cable Assembly
with a Bead Chain Connector. Make sure to use
a Bead Chain Cover.
3. After you detennine the length of Bead Chain
needed to attach to the accelerator pedal shaft,
cut Bead Chain aOO attach to the Eyelet Connector.
Make sure to use a Bead ChaiD Cover.
4. Put Screw ##10-32 x 1/2. through the holes in the
Tube Clamp. Slide the Eyelet Connedor over the
Screw. Thread Nut ##10-32 onto the Screw aOO
tighten. (Figure 12)
Threaded Tube Clamp
Bead
C~n
Cover
Screw #10 -32 x 1/2"
Eyelet Connector
Pedal Shaft
Nut 110- 32
nGURE 12
Fo...N!756, Paae'lt'