Table of Contents
Advertisement
I
Vacuum Line
Vacuum Tee
""
FIGURE
29 ~0..bl'
Cap
Suggested Vacuum Source Locations:
a. Factory Installed Tee with removable cap
(Figure 29)
b. Manifold Vacuum Tree usually with an extra
vacuum port with removable cap (Figure 30)
c. Existing Vacuum Canister mounted on vehicle
generally on the inner fenderwell or engine
bulkhead (Figure 31)
d. Existing Manifold Vacuum Line that can be
cut into (00 NOT USE BRAKE V ACUUM LINE)
(Figure 32)
IManifold Vacuwn Tree
Removable
Cap
After locating a vacuum source and making a connection.
route Vacuum Hose from the source and attach to the
vacuum port on the Servo Assembly. DO NOT forget to
remove the protective cap prior to installing the Vacuum
Hose. (Figure 33)
~
~;""
--
---2
FIGURE
30
Vacuum Check
Run the engine at idle. Unplug the Vacuum Hose from
the Servo Assembly and place your finger over the end
of the hose. You should feel a strong suction. If not,
you should find another location with stronger vacuum
or add a Vacuum Reservoir (250-3417).
~'-
To
.Intake
Manifold
'---
Insert Tee For
FIGIJRE
31 C~.
Control
i
To Other
Vehicle
To Servo Assembly
I".Q
From Intake
Manifold
Vacuum
Vacuum
Reservoir
I FIGURE
34
Form 2756, page 17
1
Advertisement
Table of Contents
