Viessmann VITOLIGNO 300-C Operating Instructions Manual page 20

Central Heating
Setting a Time Program
20
(continued)



When setting switching times, note that your heating
system requires some time to heat the interior to the
required temperature.


Note: For the period between the specified switching
Setting switching times
Press the following keys:
1.
2.
3.
4.
5. d to confirm.
6.
7. d to confirm.
8.
9. d to confirm.
10.
11. d to confirm.
12.
13. d to confirm.
14. To adjust the beginning and end of additional time
15.
For central heating, up to 4 changes between standard
and reduced room temperature can be programmed
per day (4 time phases).
At the factory, time phase ! is set for every day
from 6:00 am to 10:00 pm (06:00 to 22:00 h).
During that time, all rooms are heated to the standard
room temperature.
You can set switching times individually for the
following days or parts of the week:
– Same for all days of the week: Monday to Sunday
– For individual parts of the week: Monday to Friday
and Saturday to Sunday
– For each day individually: Monday, Tuesday, etc.
For the steps to set switching times.
For the steps to delete a time phase, see page 21.
times, the relevant heating circuit is regulated to
the standard room temperature.
for "Extended menu".
/ to select "Heating".
| ~
to select "Heating circuit 1" (HC1), "Heating
circuit 2" (HC2), "Heating circuit 3" (HC3) or
"Heating circuit 4" (HC4).
/ for "Heating time program".
| ~
Note: If you want to terminate the set switching
times prematurely, press ä until the default
display is shown (see page 12).
/ until the required part of the week or day
| ~
appears.
/ to select the time phase.
| ~
The relevant time phase is represented by
a number (!, ?, § or $).
/ for the start point of the time phase.
| ~
/ for the end point of the time phase.
| ~
phases, proceed as described in steps 9 to 14.
until the default display is shown.
Vitoligno 300-C Operating