Basic Procedures And Configuration Examples; Basic Procedures - Omron DeviceNet CV Series Operation Manual

Basic Procedures and Configuration Examples

2-1 Basic Procedures and Configuration Examples
2-1-1

Basic Procedures

Preparing the Units
1,2,3...
Setting and Wiring Hardware
1,2,3...
Starting Communications
1,2,3...
Checking Operations
1,2,3...
14
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
The examples shown here provide the basic operating procedures for
DeviceNet.
Use the following procedures to operate the DeviceNet Slave Units. For
details on settings and connections, refer to the operation manual for the
Master Unit. For further details on Slave Units, refer to SECTION 4 General-
purpose Slaves to SECTION 6 Special I/O Slave Units Specifications .
1. Select the appropriate Units. Refer to page 15 .
2. Determine the appropriate wiring method. Refer to page 15 .
3. Determine the appropriate method for supplying communications power.
Refer to page 15 .
1. Separate and lay the cables.
2. Mount the Master Unit and specify the correct settings. Refer to page 16 .
3. Mount the Slave Units and specify the correct settings. Refer to page 17 .
4. Mount other devices to be connected to the Network. Refer to page 15 .
5. Connect the cables. Refer to page 15 .
6. Wire the I/O cables. Refer to page 15 .
1. Create the I/O tables. Refer to page 20 .
2. Start up the system. Refer to page 20 .
3. Create and register the scan list. Refer to page 21 .
1. Check the status of the indicators on the Unit. Refer to page 24 .
2. Check that data is reading and writing properly. Refer to page 24 .
Note The examples provided in this section show the minimum settings to operate
the system. If details on other settings for actual operation are required, refer
the operation manual for the Master Unit. For further details on Slave Units,
refer to SECTION 4 General-purpose Slaves to SECTION 6 Special I/O Slave
Units Specifications .
Section 2-1