2.9
Installing a floppy disk drive
The barebone system comes with one 3.25-inch drive bay for a floppy disk
drive.
To install a floppy disk drive:
1.
Remove the front panel cover.
For instructions on how to remove the front panel cover, refer to section
"2.3 Removing the side plates and front panel cover" on page 2-3 for
details.
2.
Carefully insert the floppy disk
drive into the floppy drive bay.
3.
Push the optical drive into the
bay until its screw holes align
with the holes on the bay as
shown.
3.
Secure the floppy disk drive
with two screws.
2 - 2 6
2 - 2 6
2 - 2 6
2 - 2 6
2 - 2 6
2
3
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
2
2
3