Table of Contents
Advertisement
4.
Push the drive into the bay
until its screw holes align with
the holes on the bay.
5.
Secure the drive with two
screws on each side of the
bay.
6.
Connect one end of the Serial
ATA cable to the SATA
connector at the back of the
drive.
7.
Connect a 15-pin Serial ATA power plug from the power supply unit to
the power connector at the back of the drive.
Connect a 4-pin (female) power plug from the power supply unit to
the 4-pin (male) power connector at the back of the drive.
If your Serial ATA HDD has both 4-pin and 15-pin connectors at the
back, use either the 15-pin SATA power adapter plug O R
4-pin power connector. D O N O T
components and to keep the system from becoming unstable.
2 - 2 4
2 - 2 4
2 - 2 4
2 - 2 4
2 - 2 4
- O R -
- O R -
- O R -
- O R -
- O R -
D O N O T use both to prevent damage to
D O N O T
D O N O T
D O N O T
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
4
4
H D D s c r e w h o l e s
H D D s c r e w h o l e s
H D D s c r e w h o l e s
H D D s c r e w h o l e s
H D D s c r e w h o l e s
5
5
6
7
O R
O R
O R the legacy
O R
Advertisement
Table of Contents
