Table of Contents
Advertisement
2.7
Installing an optical drive
Refer to the instructions in this section to install an optical drive(s) or
5.25-inch storage devices.
• You can install an additional optical drive only if you use Serial ATA
hard disk drives.
• You cannot use the optical drive if you install two IDE hard disk
drives.
To install an optical drive:
1.
Place the chassis upright.
2.
Remove the side plate and
front cover. Refer to section
2.3 for details.
3.
Remove the drive bay plate
covers by releasing the lock
tabs.
4.
Insert the optical drive into the
upper 5.25-inch drive bay.
5.
Carefully push the optical drive
into the bay until its screw
holes align with the holes on
the bay as shown.
A S U S V i n t a g e - P E 2
A S U S V i n t a g e - P E 2
A S U S V i n t a g e - P E 2
A S U S V i n t a g e - P E 2
A S U S V i n t a g e - P E 2
3
3
5
O p t i c a l d r i v e s c r e w h o l e s
O p t i c a l d r i v e s c r e w h o l e s
O p t i c a l d r i v e s c r e w h o l e s
O p t i c a l d r i v e s c r e w h o l e s
O p t i c a l d r i v e s c r e w h o l e s
3
3
4
5
2 - 2 1
2 - 2 1
2 - 2 1
2 - 2 1
2 - 2 1
Advertisement
Table of Contents
