Asus Vintage PE2 User Manual page 41

8. Connect the other end of the
Serial ATA cable to a Serial
ATA connector on the
motherboard.
To install an IDE hard disk drive:
1. Follow steps 1-5 of the
previous section.
2. Connect the blue interface of
the IDE ribbon cable to the
primary IDE connector (blue
connector labeled PRI_IDE1)
on the motherboard.
3. Connect the gray interface of
the IDE ribbon cable to the IDE
connector on the drive.
4. Connect a 4-pin power plug from
the power supply unit to the
power connector at the back of
the drive.
A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2
S e r i a l A T A S e r i a l A T A
S e r i a l A T A S e r i a l A T A S e r i a l A T A
c o n n e c t o r s c o n n e c t o r s c o n n e c t o r s
c o n n e c t o r s c o n n e c t o r s
P R I _ I D E 1 P R I _ I D E 1
P R I _ I D E 1 P R I _ I D E 1 P R I _ I D E 1
c o n n e c t o r c o n n e c t o r c o n n e c t o r
c o n n e c t o r c o n n e c t o r
4
3
2 - 2 5 2 - 2 5 2 - 2 5 2 - 2 5 2 - 2 5