Elevation Travel Stops - Task Force Tips Typhoon Series Instructions For Installation, Safe Operation And Maintenance

4.7 ELEVATION TRAVEL STOPS

The range of elevation travel for the Typhoon Monitor is 45 degrees past vertical to 45 degrees below horizontal. The elevation range
may be limited by installing the supplied stop bolts and adjustment disks at the locations as shown. Consult factory for other ranges.
The figures include installation notes.
To change the Elevation Travel Limits:
1. Remove the Set Screw
2. Insert 1 Adjustment Disc in the bolt hole for every 10° of travel limitation
3. Replace the Set Screw with the Stop Bolt
©Copyright Task Force Tips LLC 2004-2020
30° WITH STOP BOLT
10° LESS WITH EVERY ADJUSTMENT
DISK (Y3146) INSTALLED ABOVE
THE STOP BOLT(Y4145)
45°
WITHOUT
STOP BOLT
Figure 4.7A
Elevation Travel Limits
Figure 4.7B
Elevation Travel Stop Locations
10° LESS WITH EVERY
ADJUSTMENT DISK (Y3146)
INSTALLED BELOW
THE STOP BOLT(Y4145)
45° WITH OR WITHOUT
STOP BOLT
SET SCREW
VT37-24SS250
ADJUSTMENT DISK
Y3146 (INSTALL
ABOVE STOP BOLT)
STOP BOLT
Y4145
18
LIY-050 August 17, 2020 Rev14