2. As shown in the figure, insert the light shield
between the plasma display main unit and support
.
3. Align the holes in the back cover of the plasma
display used by the screws which were removed in
step 1 with the holes in the light shield
4. Fasten the light shield
using the 3 back cover mounting screws which were
removed in step 1.
•
The screws should be securely tightened to the torque
given below.
(1.2~1.5 N•m)
Side view
Light shield
(Nonwoven fabric side)
5. Mount the light shield
using the 5 light shield mounting screws
•
The screws should be securely tightened to the
torque given below.
(1.2~1.5 N•m)
.
and back cover together
When the touch panel is used
Light shield
(Nonwoven fabric side)
onto the stand base
.
Supports
Light shield
Back cover mounting screws
Light shield
Holes used when
the touch panel is used
Light shield mounting screws
(Nonwoven fabric side)
21