Building Under A Continuous Worktop; Removing The Lid - Miele PG 8504 Operating Instructions Manual

Installation
Removing the
lid
Protective foil/
Worktop
protector
Securing to the
worktop
Venting the
circulation pump
114

Building under a continuous worktop

To build the machine under a continuous worktop the lid must be
removed as follows:
Unscrew both securing screws from the lid at the back of the

machine.
Open the door.

Unscrew the left and right fixing screws.

Lift the lid off.

The protective foil supplied protects the worktop from damage
caused by steam when the door is opened. It should be positioned
underneath the worktop above the machine door.
To improve stability the machine must be secured to the worktop
after it has been aligned.
Open the door.

Screw the machine to the continuous worktop through the holes in

the front trim on the left and right.
Please contact the Miele Customer Service Department to secure it
at the sides to adjacent cabinetry.
 The gaps between a built-in machine and adjacent cabinetry
must not be sealed, e.g. with silicone sealant, as this could
compromise ventilation of the circulation pump.