Unsatisfactory Cleaning And Corrosion - Miele PG 8504 Operating Instructions Manual

Unsatisfactory cleaning and corrosion

Problem
There are white deposits
on the wash load.
The cleaning result is un-
satisfactory.
Cause and remedy
The water softener is set too low.
Set the water softener to the correct water hardness.

There is no salt in the salt reservoir.
Refill the reactivation salt.

The quality of the water for the final rinse was insufficient.
Use water with a low conductance value.

If the machine is connected to a water softening

cartridge, check it and replace as necessary.
The water from the AD water connection is not sufficiently
softened.
Check the pre-selected water softening units. If

necessary, replace the water softening cartridge with a
new one.
Mobile units, baskets, modules and inserts were not
suitable for the load.
Select mobile units, baskets, modules and inserts which

are suitable for the task.
Mobile units, baskets, inserts and modules were incorrectly
loaded or overloaded.
Arrange the wash load correctly according to the

information in the Operating instructions.
Avoid overloading the mobile units, baskets, modules

and inserts.
The programme was not suitable for the soiling.
Select a suitable programme.

or
Adjust the parameters to suit the task.

A spray arm is blocked.
Ensure the spray arms are not obstructed when

arranging the wash load.
Injector nozzles in the mobile units, baskets, modules or
spray arms are blocked.
Check the nozzles and clean them as necessary.

The filters in the wash cabinet are dirty.
Check the filters and clean them if necessary.

Mobile units, baskets or modules were not correctly fitted
to the water connection.
Check the adapter.

Problem solving guide
105