Controller Modes; Controller Led Indicators - Pentair HOME SUMP CONTROLLER Homeowner's Manual

CONTROLLER MODES

The Sump Controller has several operational
modes that effect how the unit functions.
These include:
AUTO: This is the default operational mode of
the Sump Controller. In Auto mode, the pump
will operate either by Float Switch or by User
Button.
If the pump is turned on by the Float
‹
Switch, then it is automatically turned off
only by the Float Switch.
If the pump is turned on by the User
‹
Button, then it is only turned off by the
User Button.
MANUAL: When in Manual mode, the pump
is not operated by either the Float Switch or
User Button. It is controlled by user-defined
duration and frequency. These are set and
updated through the App.
CONTROLLER INDICATIONS
Status
Solid Green
Blinking Green
Blinking Blue
Solid Blue
Solid Red
Blinking Red
Alternating Green & Red
Alternating Green & Blue
Alternating Blue & Red
Alternating Green, Red & Blue
11
TIMER: In Timer mode, the pump will turn on
and run for the time duration set in the App.
It will automatically return to Auto mode after
the timer expires.
SERVICE: While in Service mode, it cannot
be controlled via the App. The pump can be
turned on and off with the mode button.
Additionally, pressing the mode button on
the front of the unit allows to owner to do the
following actions:
Turn pump on/off
Clear Faults / Silence Buzzer
Perform Health Test
Turn on Bluetooth®
wireless technology Pairing
Enter Service Mode
Factory Reset
Light
The unit is connected to the internet and the pump is off.
The unit is ready for Bluetooth pairing.
The unit is paired with a mobile device for provisioning.
The unit has faulted and the pump is NOT ABLE TO RUN.
The unit has faulted and the pump is able to run.
The unit is offline and not connected to WiFi.
The unit is connected to WiFi but not the Internet.
Test OK = blink green. Test Fail = blink red.
PENTAIR HOME SUMP CONTROLLER HOMEOWNER'S GUIDE
Action Button Press
1 time quickly
2 times quickly
3 times quickly
Push and hold for
Push and hold for
Power ON + Push
and hold for 4 to 10 sec
Description
The unit is running.
Check app for details.
Check app for details.
The pump is able to run.
The pump is able to run.
Health Test is running.
A firmware update is in progress
or the unit is in Service Mode.
4 to 15 sec
25 to 40 sec