Table of Contents
Advertisement
NXA-AVB/ETHERNET Specifications (Cont.)
Front Components:
Rear Components:
Included Accessories:
Other AMX Equipment:
Installing the NXA-AVB/ETHERNET
A 12 VDC-compliant power supply can indirectly provide power to an NXP-PLV by routing power
through the NXA-AVB/ETHERNET Breakout Box. FIG. 7 shows a sample wiring configuration using
both an indirect or direct power connection for a PosiTrack Pilot controller.
Indirect
Connect
12 VDC power
supply
Power
supplied via
NXA-AVB box
12 VDC power
supply
Direct
Connect
FIG. 7
Sample wiring configuration on video-capable panels using this breakout box
The breakout box unit can be mounted on either a horizontal flat surface or into an
equipment rack (by removing the front screws and attaching it to an optional AC-RK).
The power supply being used on the NXA-AVB/ETHERNET is dependent on the
power requirements of the target device.
Use a standard CAT5 Ethernet cable to provide both communication and 10/100 network connectivity
between the NXA-PLV, NXA-AVB/ETHERNET, NetLinx Master, and the network.
NXP-PLV Modero PosiTrack Pilot Camera Controller
• 2-pin 3.5 mm captive wire connector
• Green LED provides an indication of power status
• RJ-45 connector provides Ethernet signals to the touch panel
• RJ-45 connector provides differential audio and video signals to the touch
panel (panel type dependant)
• 6-pin 3.5 mm captive wire connector for in-bound (left/right channel) audio
• 4-pin 3.5 mm captive wire connector for out-bound (from microphone) audio
• BNC connector (female) for Composite or Chroma (for video-capable
panels only)
• BNC connector (female) for luminance (for video-capable panels only)
• RJ-45 connector for Ethernet input from the control system
• 2-pin 3.5 mm captive wire connector for inbound power
• Two 2-pin captive wire connectors (41-5025)
• 4-pin captive wire connector (41-5047)
• 6-pin captive wire connector (41-5063)
• Rack Mount Kit (KA2250-40) with mounting bracket (62-2254-02)
• AC-RK Accessory RackMount Kit (FG515)
• Modero Table Top Cable (CA2250-50)
Ethernet In
Mic Out
(4-pin captive-wire)
(RJ-45)
Video In
(BNC)
(6-pin captive-wire)
NXA-AVB/ETHERNET
Breakout Box
Ethernet
Audio/Video
(CAT5)
(CAT5)
or
NXP-PLV
PosiTrack Pilot Controller
Line Level out
(to amplifier
or VOL card)
Audio In
(rear)
(front)
NXP-PLV Accessories
6
Advertisement
Table of Contents
