140 Connection To The Positive Battery Terminal - Opel Movano X62 2010 Conversion Manualline

OPEL MOVANO (X62)
140 – CONNECTION TO THE POSITIVE BATTERY TERMINAL
Before working on the vehicle, refer to the "Electrical Connections" sheet.
Depending on the electrical assessment, the power take-off may be conditioned with the engine
running information.
1. General recommendations
The wiring used must allow the positive battery terminal block to be removed (tightening torque 8 Nm ±
15%).
The wiring must be red and supported inside the battery tray and as close to the terminal block as
possible in order to avoid any vibration that could lead to damage of a terminal block or loosening of
the nut. A red insulating sleeve is necessary for the terminal.
The wiring must be protected by a fuse which will be sized depending on the cross section of the wire
and on the consumer.
There are two options for connecting to the positive battery terminal, depending on the power
consumed. Any other connection to the positive terminal is prohibited.
POSITIVE BATTERY TERMINAL
1
2
1: Locations provided for midi-type fuses for power supply of less than 40 A
2: M6 stud for power supplies greater than 40 A
Note:
It is also possible to connect directly to the battery using the 2-way connector located in the B pillar, which
is available with the "KPD" and "KC5" options. Please refer to the relevant sheets for more information.
Note: Subject to errors and technical amendments. The electronic version of the body guidelines is the decisive source of
1
up-to-date data on body guidelines (online body guidelines). Data status June 2009