131 Interior Lighting - Opel Movano X62 2010 Conversion Manualline

OPEL MOVANO (X62)
131 – INTERIOR LIGHTING
Before working on the vehicle, refer to the "Electrical Connections" sheet.
1. Energy recovery conditions
The progressive ground on connectors is a delayed analogue signal. Under no circumstances may this
signal be relayed.
Excess consumption of no more than 2 A (24 W) may be taken from the rear zone and double cab lighting.
No excess consumption is feasible for front and right-hand side courtesy lights (sliding side door). Follow
the procedure for consumption greater than 2 A.
If consumption is greater than 2 A (24 W) for the rear and double cab lighting and on the front or right-hand
side lighting:
- the delayed power supply should control a relay which will control another power supply.
- a specific ground should be used (the progressive ground will no longer be usable).
If the open door information is required, a panel switch should be added.
N.B.:
For wires with a cross section of 0.5 mm², it is possible to bypass these wires by using a crimp adaptor.
However, for wires with a cross section of 0.35 mm², use of the crimp adaptor is very delicate and it is
strongly recommended to recover this information on the roof connector.
Note: Subject to errors and technical amendments. The electronic version of the body guidelines is the decisive source of
up-to-date data on body guidelines (online body guidelines). Data status June 2009
1