Step 6 Connect the Mouse
The mouse connector P003 is a five-pin berg. PS/2-
compatible mouses can be connected to this socket via a
five-pin berg to six-pin DIN mini-DIN Converter. Connect
the mouse cable to P003. The following graphic shows the
five-pin berg. The adjacent table lists the pinout.
Step 7 Connect the Cables
Most connector wires are color-coded. Match the color of
the wires leaving the switch or LED to the same pin on the
connector end. There can be two connectors with the same
color-coded wires. Follow the wire to the switch or LED.
Pin 1 of all connectors is labeled to identify the pin
orientation when plugging in cables. See the EZ-Flex Base
Board graphic on page 16.
The following cables should be connected to the Base
Board from the chassis:
•
Reset Switch cable to P016.
•
Speaker cable to P013.
AMI EZ-Flex Base Board User's Guide
Pin
Description
1
Mouse clock
2
Mouse data
3
NC
4
GND
5
VCC
27