Error Messages - American Megatrends EZ-Flex User Manual

Step 10 Perform Initial Test and
Configuration,
Continued
Configure the System
Run the AMI BIOS Setup utility. You must enter the
requested information and save the configuration data in
CMOS RAM. The system then resets, runs POST, and
boots the operating system. See the documentation on
configuring the system through Standard CMOS Setup
which begins on page Error! Bookmark not defined..
Run ECU
The EISA Configuration Utility (ECU) must be run to
configure all EISA and ISA adapter cards in the system.
See the appropriate ECU User's Guide for information
about running the ECU.

Error Messages

If the system beeps during POST (power on self test), a
serious problem exists with the system configuration or
hardware. The beeps are part of a Beep Code (see Page 51)
that almost always indicates a bad component or that the
system must be reconfigured. If a beep code sounds, make
sure the affected part is properly seated and connected. An
error message can appear on the monitor if the error is non-
fatal. Recheck the system configuration or the connections
to assure that the installation procedures were followed.
Chapter 4 Installation
48