American Megatrends EZ-Flex User Manual page 101

Message
Drive Parameter Activity
Failed
ECC Corrected Data Error
Requested Sector Not
Found
Reset Failed
Seek Operation Failed
Undefined Error -
Command Aborted
Write Fault on Selected
Drive
AMI EZ-Flex Base Board User's Guide
Explanation
The hard disk drive utility waited beyond a
preset specified time limit.
A reset command was sent to the controller
followed by drive parameters. Using these
parameters, the controller did not get a
response from the hard disk. Make sure the
drive type is correct.
The ECC value (explained above) read from
the disk is not the same value which was
written to the disk. The data is not correct. An
attempt was made to correct the data, but the
ECC value is not corrected.
The requested sector could not be found.
The reset command did not properly reset the
hard disk.
A seek command failed. A seek operation is
the act of finding a particular sector on the
hard disk.
An unidentifiable error condition occurred.
A write fault occurred during the write
operation on the hard disk drive.
95