American Megatrends Enterprise-III User Manual page 42

Step 9 Connect Cables,
D5 Turbo LED Connector
D5 is a two-pin berg that connects to the Turbo LED via a cable. The LED lights when the board runs at high speed.
Connect the Turbo LED to D5. D5 is shown below. See the graphic at the top of page 65 for the D5 location.
J14 Turbo Switch Connector
J14 is a two-pin berg that connects to the turbo switch mounted on the chassis via a cable, as shown below. The turbo LED
switch is bipolar. You can select Low or High speed by pressing the turbo switch, attached to J14 via a connector
cable. J14 is shown below. See the graphic at the top of page 65 for the J14 location.
Enterprise-III EISA VLB Motherboard User's Guide
Continued
67