Table of Contents
Advertisement
Chapter 2
Installation
Unpacking
Step
1.
Inspect the cardboard carton for obvious damage. If damaged, call
AMI Technical Services at 404-263-8181.
Leave the Baby Voyager motherboard in its original packing.
2.
Perform all unpacking and installation procedures on a ground
connected anti-static mat. The operator should wear an anti-static
wristband, grounded at the same point as the anti-static mat. Or
use a sheet of conductive aluminum foil grounded through a 1
megohm resistor instead of the anti-static mat. Similarly, a strip of
conductive aluminum foil wrapped around the wrist and grounded
through a 1 megohm resistor serves the same purpose.
3.
Inside the carton, the Baby Voyager motherboard is packed in an
anti-static bag, and sandwiched between sheets of sponge.
Remove the sponge and remove the anti-static bag. Place the
Baby Voyager motherboard on a grounded anti-static surface
component-side up. Save the original packing material in case of
reshipment.
4.
Inspect the motherboard for damage. Press down on all ICs
mounted in sockets to verify proper seating. Do not apply power
to the motherboard if it has been damaged.
5.
If the motherboard is undamaged, it is ready to be installed.
Action
AMI Baby Voyager User's Guide
7
Advertisement
Chapters
Table of Contents
