American Dynamics SpeedDome Ultra VIIE Installation And Service Manual page 13

4. For the dome at the end of a daisy chain, set
termination jumper JW1 on the dome CPU
board (Figure 13) to "terminated."
Position of dome in
communications line...
Between other devices
End of communications line
* Pins 1-2 are closest to 9-pin connector.
Note: You may need a small slotted screwdriver
to gently pry the jumper loose. Be careful not to
damage the underlying PC board.
Figure 13. Video cable connection and
termination jumper location
Micro
Coax
Cable
5. Connect the 9-pin plug (data and power) to the
9-pin receptacle (Figure 14). If using a Pelco
Coaxitron or Panasonic UTC protocol, no data
wires are connected, just power.
CAUTION: DO NOT connect the 9-pin plug
unless you have performed step 3 first!
a. Feed cables through the access hole in the
base.
SPEEDDOME ULTRA VII AND ULTRA VIIE CAMERA DOME
INSTALLATION AND SERVICE GUIDE
Setting Pins
Unterminated 1-2*
Terminated 2-3
Termination
Jumper JW1
13 of 38
b. Connect data and power wires to the 9-pin
plug (refer to charts below).
c. Insert the plug into the mating receptacle in
the top of housing and eyeball assembly.
Manchester data and power connections.
Order data cable 88760 (plenum) or 8760
(non-plenum) from Belden by calling
1-800-235-3361.
Pin Color Designation
1 White Manchester (–)
2 Black Manchester (+)
3 Black 24Vac
4 Red Ground
5 White 24vac
6-9 — Not used.
RS-422/Pelco P data and power connections
Pin Color Designation
1-2 — Not used.
3 Black 24Vac
4 Red Ground
5 White 24Vac
6 Orange RS-422 Data In High (+)
7 Green RS-422 Data In Low (–)
8 Yellow RS-422 Data Out High (+)
9 Brown RS-422 Data Out Low (–)
SensorNet data and power connections
Pin Color Designation
1 Orange SensorNet (unshielded)
2 Yellow SensorNet (unshielded)
3 Black 24Vac
4 Red Ground
5 White 24Vac
6-9 — Not used.
8200-0184-01, REV. E