Table of Contents
Advertisement
TROUBLESHOOTING
The ORANGE LED
E1
flashes 1 x.
1
The ORANGE LED
E2
2
flashes 2 x.
The ORANGE LED
E4
flashes 4 x.
4
The ORANGE LED
E5
5
flashes 5 x.
The ORANGE LED
E8
8
flashes 8 x.
The ORANGE LED
is on.
The RED LED flashes
quickly after an
assisted setup.
The RED LED
flashes
sporadically.
The LED and the
LCD-display are off.
The reaction of
the door does not
correspond to the
LED-signal.
The LCD or remote
control does not
react.
Page 6 of 8
The sensor signals
an internal fault.
The power supply voltage
is too low or too high.
The sensor does not receive
enough AIR-energy.
The sensor receives
too much AIR-energy.
The AIR power emitter is
faulty.
The sensor encounters
a memory problem.
The sensor sees the door
during the assisted setup.
The sensor vibrates.
The sensor sees the door.
The sensor is disturbed
by external conditions.
The sensor is protected by
a password
Cycle power supply.
1
If orange LED flashes again, replace sensor.
2
1
Check power supply
2
Check wiring.
Check the angle and width setting of the AIR-curtains.
1
Increase AIR-immunity filter to value 2 (enhanced).
2
1
Check the angle of the AIR-curtains.
2
Decrease the AIR immunity filter to value 1 (normal).
1
Relearn AIR.
2
Replace sensor.
1
Cycle power supply.
2
If orange LED turns on again, replace sensor.
1
Check the angle of the AIR-curtains.
2
Launch a new assisted setup.
Attention: Do not stand in the detection field!
1
Check if the sensor is mounted firmly.
Check position of cable and cover.
2
1
Launch an assisted setup and adjust the AIR angle.
1
Increase the AIR-immunity filter to value 2 (enhanced).
1
Cycle power supply.
2
Check wiring.
1
Check output configuration setting.
2
Check wiring.
1
Enter the correct password. To access the
sensor without a password, cycle power.
Sensor may be accessed for 1 minute.
Download the BEA DECODER
app for a quick overview
of settings
75.5785.01 IXIO-ST UL INDUSTRIAL 20140402
(in the diagnostics menu of the LCD).
Advertisement
Table of Contents
