Programming Functions - American Dynamics MegaPower 3200 Operator's Manual

Function
Control Tour
Call Salvo
Acknowledge Alarm
Control Auxiliary
View Satellite Sites
Disconnect/Log Off
Satellite
DirectSet
(SensorNet only)
(1)
Note: Auxiliary 4 is not supported by all receiver/driver and dome protocols and configurations.

Programming Functions

Note: The following functions can only be performed with the keyboard in Program (P) mode, indicated by a
"P" displayed in the lower right of the LCD. Enter P mode before starting the step sequence listed for each
function.
To enter P mode from a locked (L) state, enter your password and press Lock. If you need to obtain the
password, please contact your system administrator.
Function
Program Presets
Program Patterns
Clear Patterns
(RS-422 only)
Program Monitor Tours
Arm Monitor
Disarm Monitor
Display Current
Monitor Arming Type
MEGAPOWER CPU
OPERATOR'S GUIDE
Actions
Press Next or Last to change direction (forward or reverse) for executing a tour
Press Hold to hold a tour
Press Run to restart a tour
Press Next or Last to manually step through the cameras of a tour that is on hold
-Call first monitor in group
-Call alarming monitor
-Call camera -specify the Auxiliary number (1–4)
Auxiliary Off to turn an auxiliary on or off
Note:
Pressing Auxiliary On or Off without specifying the number activates the previously
specified Aux number.
-Call local monitor #
-Press Site -call local camera
•
-Press Hold only to display or close the DirectSet menu when not running a
tour or attached to an alarming monitor, or
•
-Enter 0 -press Hold to display or close the DirectSet menu, or
•
-Enter a number
or not the menu is displayed
Note:
All SpeedDome Optima camera domes can receive DirectSet commands, but do
not display the menus.
Action
-Call monitor and camera
Preset # -press Preset Enter (or Shot Enter)
-Call monitor and camera
-maneuver camera
-Call camera -enter Pattern #
-Call monitor -enter 62
CAMERA -enter dwell time (1-60)
subsequent cameras in tour (up to a maximum of 64 entries)
-Call monitor -enter arming type ID # (301–315)
-Call monitor -enter 316
-Call monitor -enter 300
-enter Salvo #
-press Ack
-enter site # -press Site
-press Hold to select a DirectSet menu command whether
-press + -move camera to position
-enter Pattern #
-press Ack
-press Pattern
-press Prog -enter camera #
-press Prog
-press F2
-press F2
18 of 20
-press Salvo
(1)
-press Auxiliary On or
-call remote camera #
-enter
-press – (minus)
-press Pattern -press Prog
-press Clear
-press
-repeat steps 4–7 for all
-press Run
-press F2
8200-0421-02, REV. D