Programming Functions - American Dynamics MegaPower 3200 Operator's Manual

Programming Functions

Note: Functions having an asterisk (*) in the Function column require a supervisor or administrator-level Smart
Card for access to the PROGRAM MODE tab key.
Function
* Program Presets
* Program Patterns
* Clear Patterns
(RS-422 only)
* Program Monitor
Tours (Scratchpad
Program)(see Note)
Program Monitor
Tours (Operator-Level
Smart Card) (see
Note)
Note: Pressing the PROG S PAD
"TR CLR" message displays momentarily in the monitor's Status field.
MEGAPOWER CPU
OPERATOR'S GUIDE
Action
-Call monitor and camera
-press PROGRAM MODE tab key
-press PROGRAM PRESET
-Call monitor and camera
-press PROGRAM PATTERN soft key
-press PATTERN
-press END soft key
-Press PROGRAM MODE tab key
-press PROGRAM PATTERN soft key
-press Pattern # -press CLEAR soft key
-press PROGRAM MODE tab key to exit
-Call monitor -press PROGRAM MODE tab key
-press KEYB CONFIG soft key
-enter camera #, and press ENTER
-enter dwell time (1-60)
-repeat steps 5–7 until all cameras are programmed (or the maximum count of 64
entries is reached)
-press OPERATOR tab key
-Call monitor -press USER SETTINGS tab key
-press PROG S PAD
-enter camera #, and press ENTER
-enter dwell time (1-60)
- repeat steps 4–6 until all cameras are programmed (or the maximum count of 64
entries is reached)
- press OPERATOR tab key
soft key deletes the previously programmed sequence, and the
-move camera into position
-enter Preset #
soft key
-press PROGRAM MODE tab key
-enter a number (1-3)
soft key -maneuver camera
-press PROGRAM MODE tab key to exit
-press PROG S PAD
-press DWELL TIME soft key
press Run
soft key
soft key
- press DWELL TIME soft key
-press Run
13 of 20
soft key
soft key
soft key
8200-0421-02, REV. D