Programming Functions - American Dynamics MegaPower 3200 Operator's Manual

Function
Control Auxiliary
View Satellite Sites
VCR Mode
Disconnect/Log Off
Satellite
DirectSet
(SensorNet only)

Programming Functions

Function
Program Presets
Program Patterns
Clear Patterns
(RS-422 only)
Program Monitor Tours
Arm Monitor
Disarm Monitor
Display Current
Monitor Arming Type
MEGAPOWER CPU
OPERATOR'S GUIDE
Actions
-Call camera -select auxiliary number 1–4
turn the specified auxiliary on or off
Note: Not all domes/receiver drivers support AUX4.
-Call local monitor #
-Turn keyswitch to OPERATE
function by pressing the appropriate key shown below:
VCR Function Icon
Stop
Record
Pause
Play
Rewind
Fast Forward
Eject
-Press SITE -call local camera
•
-Press Hold only to display or close the DirectSet menu when not running a
tour or attached to an alarming monitor, or
•
-Enter 0 -press Hold to display or close the DirectSet menu, or
•
-Enter a number
or not the menu is displayed
Note:
All SpeedDome Optima camera domes can receive DirectSet commands, but do
not display the menus.
Action
-Call monitor and camera
position -enter Preset #
-Call monitor and camera
-press PATRN -press PROG
-Set keyswitch to PROGRAM
-press CLEAR
-Call monitor -set keyswitch to PROGRAM
-enter camera # -press CAM
-repeat steps 4–6 until all cameras have been programmed (or the maximum count
of 64 entries is reached)
-Call monitor -set keyswitch to PROGRAM
-enter arming type ID # (301–315)
-Call monitor -set keyswitch to PROGRAM
-Call monitor -set keyswitch to PROGRAM
-enter site # -press SITE
-enter VCR #
Key Label
Off
On
Close
Open
Near
Far
ACK
-press Hold to select a DirectSet menu command whether
-set keyswitch to PROGRAM
-press PRESET
-set keyswitch to PROGRAM
-maneuver camera
-enter Pattern #
-enter dwell time, the press PROG
-press RUN to run the Tour
-press F2
10 of 20
-press AUX ON or AUX OFF to
-call remote camera #
-Press VCR -Select VCR
-move camera to
-set keyswitch to OPERATE
-enter Pattern #
-press ACK
-press PATRN
-enter 62, then press PROG
-press 316, then F2
-press 300, then F2
8200-0421-02, REV. D