American Dynamics AD715LS Series Installation And Service Manual page 29

Removing the Slot Covers
1. Gently swivel eyeball to totally expose one of
two slot covers (Figure 25).
CAUTION: Swiveling fast can damage gears.
2. Insert small, thin-bladed screwdriver into space
between cover and eyeball.
3. Gently pry off slot cover.
4. Gently swivel eyeball to totally expose
remaining slot cover. With other cover removed,
this cover can be easily removed.
Figure 25. Removing slot covers
INSTALLATION AND SERVICE GUIDE
Removing the Camera
1. Perform procedure "Removing the Slot Covers"
(page 29).
2. Remove ribbon cable from camera (Figure 22).
Swivel camera yoke to expose camera
connector. Then, using a small slotted
screwdriver, 1) gently pry camera connector
loose from camera, and 2) pull it down through
cable tie wrap.
Figure 26. Removing the ribbon cable
1
3. Remove camera (Figure 27).
1) Loosen the screw holding the camera tripod
mount, then 2) carefully lift the camera out.
Figure 27. Removing the camera
Reverse steps to reassemble. Ensure ribbon
cable pins are inserted "face down".
29
2
2
1
DeltaDome II Camera Dome
8000-2708-01, REV. B