American Dynamics AD715LS Series Installation And Service Manual page 16

8. Connect housing and eyeball assembly to base
(Figure 14).
a. Align dimple on cap of dome with rib on
mounting base.
b. Mate housing and eyeball assembly to base
and turn it clockwise until you hear a click.
Figure 14. Connecting housing and eyeball
assembly to base (cables and lanyard not
shown)
INSTALLATION AND SERVICE GUIDE
9. Wait a few seconds for dome to begin its
homing routine. Homing routine indicates that
address was placed into dome memory and that
dome is ready for programming.
16
DeltaDome II Camera Dome
8000-2708-01, REV. B