American Dynamics ADTT16E Operator's Manual page 80

Multiplexer Live Mode Problems
Problem Description
All LIVE pictures too
bright, too dark, or
incorrect color.
Some LIVE pictures too
dark.
Multiplexer Tape Mode Problems
Problem Description
Poor or unstable pictures.
VCR not recording.
Multiplexer Motion Detection Problems
Refer to the Multiplexer Operator's Manual for information about changing these settings.
Problem Description
Important camera motion
not detected.
Unimportant camera
motion detected.
6-12
Possible Solution
•
The monitor may not be properly adjusted. Adju
multiplexer gray bars.
•
The camera iris may not be correctly adjusted. Adjust
the camera iris using a calibrated monitor
Possible Solution
•
The VCR may be faulty or require maintenance.
Perform periodic maintenance and test VCR
performance.
•
Make sure the VCR is connected to an electrical
receptacle and is turned on.
•
Make sure a tape cartridge is inserted into the VCR.
Possible Solution
•
Required camera motion targets may be turned off.
Perform the motion detection setup and turn on the
required motion targets.
•
Motion detection sensitivity may be too low. Adjust
the motion sensitivity setting.
•
Delay setting is too long. Adjust the delay setting.
•
Unnecessary camera motion targets may be turned
on. Perform the motion detection setup and turn off
the undesired motion targets.
•
Motion detection sensitivity may be too high. Adjust
the motion sensitivity setting.
•
Delay setting is too short. Adjust the delay setting.
ADTT16E Advanced Dome Controller Operator's Manual
st the