American Dynamics ADTT16E Operator's Manual page 52

Pattern Programming Instructions
1. Select the camera for the Pattern you want to program.
2. Adjust the pan, tilt, zoom and focus settings for the camera until the starting point for the
Pattern appears on the monitor.
3. Press Menu.
4. Scroll through the menu until Record Pattern appears on the LCD. Press Zoom or
Focus to select.
5. Enter Patrn#? appears on the LCD. Enter the Pattern number (1-3).
The following information appears on the LCD:
Record Pattern 98
Finish w <Next>
6. Move the camera around and create the Pattern. The LCD displays the number of
remaining commands while the Pattern in programmed.
7. Press Next when finished programming. Pattern Saved appears briefly on the LCD.
The controller automatically returns to camera control mode after saving the Pattern. Make a
record of the Pattern, including the camera number and a brief description in the
Programming Worksheets (8200-0306-04).
Programming Time Saver
To quickly program a Pattern, first adjust the camera to the starting point of the
Pattern. Press Menu, and then press Pattern. Enter the Pattern number (1-3) to
start programming. Move the camera in the desired pattern. When finished
programming, press Next to save the Pattern.
4-4
Available commands
ADTT16E Advanced Dome Controller Operator's Manual