American Dynamics SpeedDome Ultra 8 Installation And Service Manual page 23

Removing the Camera/Lens Board
1. Perform procedure "Removing the Slot Covers"
(page 21).
2. Perform procedure "Removing the Camera"
(page 22).
3. Perform procedure "Detaching the Eyeball"
(page 22).
4. Separate the yoke brackets (Figure 24).
Figure 24. Separating the yoke brackets
5. Gently pry off the yoke bracket covering the
camera/lens board to access the bearing
assembly (Figure 25).
Figure 25. Removing the yoke brackets
SPEEDDOME ULTRA 8 CAMERA DOME
INSTALLATION AND SERVICE GUIDE
The following steps refer to Figure 26.
6. Access camera/lens board.
To do this, loosen captive retaining screw
holding bearing assembly in place and remove
this assembly.
7. Remove cables from camera/lens board.
a. Small amber ribbon cable is from tilt motor.
Unplug this cable from connector J3 on
camera/lens board.
b. Large gray ribbon cable is from slip ring
connector. Unplug this cable from connector
J2 on camera/lens board.
DO NOT unplug small white ribbon cable from
connector J1.
8. Push out on the three prongs to detach the
camera/lens board.
9. Reverse the steps to reassemble.
Figure 26. Removing the camera/lens board
Camera/Lens Board
23 of 30
Prongs (3)
DO NOT unplug
cable from J1.
J3 (Pins on ribbon
cable must face
contacts on
connector.)
Bearing Assembly
8200-0600-03, REV. B