American Dynamics SpeedDome Ultra 8 Installation And Service Manual page 21

Removing the Pan Motor
Referring to Figure 18.
1. Perform procedure "Removing the P/S Board"
(page 20).
2. Remove pan motor.
a. Lift the motor housing up as shown to
disengage the motor from the pan gear.
b. Then pull the motor bracket towards the
outside of the housing to remove it.
3. Reverse the steps to reassemble.
CAUTION: When putting in a new motor, be
careful to properly mesh motor and pan gears!
Failure to do so can destroy both motor and pan
gear. Verify pan gear turns freely!
Figure 18. Removing the pan motor
b. Pull out
a. Lift up
SPEEDDOME ULTRA 8 CAMERA DOME
INSTALLATION AND SERVICE GUIDE
Removing the Slot Covers
1. Gently swivel eyeball to totally expose one of
two slot covers (Figure 19).
CAUTION: Swiveling fast can damage gears.
2. Insert small, thin-bladed screwdriver into space
between cover and eyeball.
3. Gently pry off slot cover.
4. Gently swivel eyeball to totally expose
remaining slot cover. With other cover removed,
this cover can be easily removed.
Figure 19. Removing slot covers
21 of 30
8200-0600-03, REV. B