Tuning Digital Television Stations - Grundig 26 VLC 4010 C Manual

SPECIAL­SETTINGS
Tuning­digital­television­stations
This search deletes all television stations in-
cluded in the channel list!
Tuning­all­digital­television­stations­
with­cable­connection­by­auto­tun-
ing
1 Open the menu with »M«.
– The »PICTURE« menu appears.
2 Select the »CHANNEL SETUP« menu with
CHANNEL SETUP
Auto Tuning
Digital Manual Tuning
Analogue Manual Tuning
Programme Table
Signal Information
CA - Module
Active Antenna Power
Select
» « or » «.
r e
3 Select »Auto Tuning« with »
confirm with »OK«.
4 Select »Country Selection« by pressing »
or » « and press »
w r
setting.
5 Select the »Scan Type« with »
» « or » « to select the »DTV«.
r e
6 Select the »TV Connection Type« with »
Press » « or » « to select the »Cable« and
r e
press »OK«.
– »Scan Type« is active.
7 Press »
« or » « to select the scan type
r e
»quick« or »Full«.
– » quick« scanning function sets the channels
according to the cable operator information
in the broadcasting signal.
­-----------------------------------------------------------------------------------------------------
s
s
s
s
Not Inserted
On
Back
Exit
« or » « and
q w
q
« or » « to make the
e
« and press
q
«.
q
– N etwork ID« performs the installation that
is suitable to your network. If you know
the Network ID, please enter it; otherwise
please select Auto Recommended settings
for »Frequency« or »Symbol Rate« is
»Auto«.
– S elect »Full« if the scanning can not be
performed with »Fast« option.
– A ll current channels are set and stored in
»Full« scanning. This scanning process can
take a long time. This option is recommend-
ed if your cable operator does not support
fast scanning function.
8 Start the search with »OK«.
– T he »Searching...« menu appears, and the
search for digital TV stations begins. This
may take several minutes depending on the
number of television stations received.
– The search is ended when the »Programme
Table« appears.
Note:
You can stop the search by pressing »
7
Tuning­the­digital­television­stations­
with­cable­connection­–­by­entering­
the­frequency
1 Open the menu with »M«.
– T he »PICTURE« menu appears.
«
2 Select the »CHANNEL SETUP« menu with
» « or » «.
r e
3 Select »Digital Manual Tuning« with »
» « and press »OK« to confirm.
w
– T he »Digital Manual Tuning« menu ap-
pears.
4 Enter Frequency (with 6 digits), Symbol Rate,
Modulation directly with »
»OK« to confirm.
– T he search is finished when the channels
found appear in the list.
M
5 Press » « to end the setting.
M
«.
« or
q
« and press
1­...­0
25­
ENGLISH