SPECIALSETTINGS
Tuningdigitaltelevisionstations
This search deletes all television stations in-
cluded in the channel list!
Tuningalldigitaltelevisionstations
withcableconnectionbyautotun-
ing
1 Open the menu with »M«.
– The »PICTURE« menu appears.
2 Select the »CHANNEL SETUP« menu with
»
« or »
«.
r
e
CHANNEL SETUP
Auto Tuning
Digital Manual Tuning
Analogue Manual Tuning
Programme Table
Signal Information
CA - Module
Active Antenna Power
Select
3 Select »Auto Tuning« with »
confirm with »OK«.
4 Select »Country Selection« by pressing »
or »
« and press »
w
setting.
5 Select the »Scan Type« with »
»
« or »
« to select the »DTV«.
r
e
– T he »Searching...« menu appears, and the
search for digital TV stations begins. This
may take several minutes depending on the
number of television stations received.
– The search is ended when the »Programme
Table« appears.
Note:
You can stop the search by pressing »
7
M
6 Press »
« to end the setting.
30
ENGLISH
-----------------------------------------------------------------------------------------------------
s
s
s
s
Not Inserted
On
Back
Exit
« or »
« and
q
w
« or »
« to make the
r
e
« and press
q
M
Tuninganaloguetelevisionsta-
tions
This setting is only necessary if you cannot re-
ceive any digital stations and you have not car-
ried out an analogue search during initial setup.
The television station can be set directly or using
the search.
Switchingthetelevisiontoana-
loguechannels
1 Open the »INPUT SOURCE« menu by press-
ing »
«.
2 Select input source »ATV« with »
and press »OK« to confirm.
Note:
Additional operations are explained in the
7
following sections.
Re-tuningallanaloguetelevision
channels
These settings are only necessary if you can not
receive any digital stations or if you want to re-
tune all analogue channels.
The analogue television stations are listed in the
channel list after the digital television stations.
Note:
«
q
Plug the rooftop antenna cable (for ana-
7
logue television stations) into the »ANTIN«
socket on the television.
1 Open the menu with »M«.
– T he »PICTURE« menu appears.
2 Select the »CHANNEL SETUP« menu with
»
« or »
r
e
3 Select »Autotuning« with »
confirm with »OK«.
4 Select »Country Selection« by pressing »
or »
« and press »
w
setting.
5 Select the »Scan Type« with »
«.
Press »
« or »
r
and start the search with »OK«.
«.
« or »
q
« or »
« to make the
r
e
«.
q
« to select the »ATV« display
e
« or »
«
q
w
« and
w
«
q